Aquario Neo CO2 Special Curved introduces fine CO2 bubbles through a small diffusion surface. The pre-curved shape hangs over the aquarium edge without requiring a suction cup to support the diffuser itself. Supplied suction cups can secure the CO2 line outside the glass.
Choose the size and rim fit
The transparent design includes a built-in bubble counter and a resilient polycarbonate pipe. The low diffuser body and side connection keep the assembly compact. Compare the length and glass limit together; a larger diffuser may also be used in a smaller tank when the installation fits.
| Size | Aquarium guide | Length | Maximum glass | Clip width |
|---|---|---|---|---|
| S | Up to 20 gallons | 23 cm | 8 mm | 9 mm |
| M | 20–40 gallons | 28 cm | 8 mm | 9 mm |
| L | 40+ gallons | 34 cm | 12 mm | 13 mm |
Initial setup
Soak the diffuser for 30 minutes in slightly warm water, never boiling water, before use. Connect it to the regulator and increase pressure slowly. The stated operating range is 10–30 PSI; excessive pressure may damage the diffuser.
Choose the CO2 version for this application. The product information distinguishes a brown CO2 diffusion element from a white air version; the two versions are not interchangeable.
Cleaning and handling
When bubbles become larger, the existing cleaning instructions specify a ten-minute soak in a solution of one part bleach to ten parts water, followed by repeated rinsing to remove all bleach before reuse. Follow the product’s current care directions and keep the cleaning solution outside the aquarium.
The care instructions describe a small amount of thin cyanoacrylate adhesive to repair a leaking edge seal. Keep adhesive off the diffusion surface, wear gloves and avoid skin contact because it bonds skin rapidly. Check the manufacturer’s guidance for the particular damage before attempting a repair.
Confirm the S, M or L option before ordering. The illustration below shows the curved diffuser family and supports comparison of the different profiles.








